วิธีการใส่แรม Dell PowerEdge T300

Pravit

MemoryToday.com ผู้ให้บริการ "เพิ่มแรม" และผู้จำหน่าย "SSD" อันดับ 1 ของประเทศไทย !!
สอบถามราคา และ การบริการ โทร. 02-641-0055

Dell PowerEdge T300

System Memory

The six memory module sockets are located on the system board adjacent to the power supply and can accommodate 512 MB to 24 GB of registered PC2-4200/5300, 533/667-MHz, DDR2 memory with ECC. See Figure 6-1 for the location of the memory module sockets.

You can upgrade the system memory by installing combinations of 512-MB, 1-GB, 2-GB, and 4-GB memory modules. You can purchase memory upgrade kits from Dell.

NOTE: Memory modules must be PC2-4200/5300 compliant for your system.

Memory Module Installation Guidelines

The memory module sockets are arranged in three banks (1, 2, and 3) on two channels (A and B).

The memory module banks are identified as follows:
Bank 1: DIMM1_A and DIMM1_B
Bank 2: DIMM2_A and DIMM2_B
Bank 3: DIMM3_A and DIMM3_B

Memory modules must be installed in memory module banks in identical pairs for configurations with more than one memory module. For example, if socket DIMM1_A contains a 512-MB memory module, then the second memory module to be installed must be a 512-MB memory module in socket DIMM1_B.

Table 3-1 shows examples of different memory configurations, based on the
following guidelines:
• The minimum memory configuration is 512 MB.
• If only one memory module is installed, it must be installed in the DIMM1_A socket.
• A memory module bank must contain identical memory modules.
• Install memory modules in bank 1 (DIMM1_x) before installing memory modules in bank 2 (DIMM2_x), and install memory modules in bank 2 before installing memory modules in bank 3 (DIMM3_x).
• Configurations of three or five memory modules are not supported.